Optional Accessories (Sold Separately); Battery Removal/Installation - Hitachi Koki CR 18DMR Instrucciones De Manejo

OPTIONAL ACCESSORIES (sold separately)

1. Battery (EB1820L, EB1824L, EB1826HL, EB1830HL,
EB1830X, EB1833X, EBM1830)
2. Blades
(1) No. 1 Blade
(2) No. 2 Blade
(3) No. 3 Blade
(4) No. 4 Blade
(5) No. 5 Blade
(6) No. 8 Blade
(7) No. 9 Blade
(8) No. 95 Blade
(9) No. 96 Blade
(1) – (9) : HCS Blades (HCS : Highspeed Carbon
Steel)
(10) – (20) : Bl-METAL Blades
Refer to Table 3, 4 and 5 for use of the blades.
Optional accessories are subject to change without
notice.
APPLICATIONS
Cutting pipe and angle steel.
Cutting various lumbers.
Cutting mild steel plates, aluminum plates, and
copper plates.
Cutting synthetic resins, such as phenol resin and
vinyl chloride.
For details refer to the section entitled "SELECTION OF
BLADES".

BATTERY REMOVAL/INSTALLATION

CAUTION
Be sure to keep the switch turned off and the lock-
off button moved to right position (lock position)
(See Fig. 18).
1. Battery removal
Hold the housing tightly and push the battery latches
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
(10) No. 101 Blade
(11) No. 102 Blade
(12) No. 103 Blade
(13) No. 104 Blade
(14) No. 105 Blade
(15) No. 106 Blade
(16) No. 107 Blade
(17) No. 108 Blade
(18) No. 121 Blade
(19) No. 131 Blade
(20) No. 132 Blade
CHARGING
〈 UC24YFA, UC18YRL 〉
Before using the power tool, charge the battery as
follows.
1. Connect the charger's power cord to a receptacle
When the power cord is connected, the charger's
pilot lamp will blink in red (At 1-second intervals).
2. Insert the battery into the charger
Insert the battery firmly, until it contacts the bottom
of the charger compartment.
CAUTION
If the battery is inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause problems in the charger such as
deformed recharging terminal.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light up
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red (At 1-second intervals) (See
Table 1).
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
English
10