Installation - Enraf Nonius Endopuls 811 Manual Del Usuario

10 Installation

NOTE:

Before starting up the system, remove the Endopuls 811 from its transport case. Do not operate
the device while it is in the case.

Ensure that the Endopuls 811 is placed on a stable surface

Make sure that the main switch on the device is set to '0'.
Connecting the mains cable

Insert the mains cable into socket [6] and connect it to a wall socket.
Connecting the hand-piece

Plug the hand-piece into the appropriate socket [7] of the device and place it on the table
NOTE:
Ensure that an applicator is inserted into the hand-piece and that it is properly screwed in as far as it will
go.
Connecting the footswitch

Plug the footswitch into the appropriate socket [8] of the device and then place it on the floor.
Switching on the device

Switch on the device using the main switch [5].
48