-
Before cleaning, switch off the unit and let it cool down.
-
In the event of electrically supplied units, use the isolator
switch to disconnect the mains.
Carefully clean daily the appliance to guarantee its proper
operation and long life.
Steel surfaces must be cleaned with a dish washer detergent
diluted in very hot water by using a soft cloth; for the
toughest dirt, use ethylic alcohol, acetone or another
non-halogenated solvent; do not use abrasive powder
detergents or corrosive substances such as hydrochloric
acid, muriatic or sulphuric acid. The use of acids can
aff ect the unit's operation and safety. Do not use brushes,
steel cottons or abrasive disks made with other metals or
alloys that might cause rust stains due to contamination. For
the same reason, avoid contact with iron objects. Do not use
steel cottons or stainless steel brushes because whilst they
will not contaminate surfaces, they can cause damaging
scratches.
If dirt is tough, do not use sandpaper or rough paper, but use
synthetic sponges (for example Scotchbrite sponges).
Do not use substances for cleaning silver and be careful with
hydrochloric or sulphuric vapours coming from fl oor washing
products, for example. Do not aim water jets directly on
the appliance, it might be damaged. After cleaning, rinse
properly with clean water and dry carefully with a cloth.
IMPORTANT
To use the pyroceram tops at their best, follow the
recommendations and instructions:
1) after cooking remove all dirt and food residuals from the
surface by using a proper scraper.
2) pour a few drops of a detergent suitable for pyroceram
surfaces on the cold surface and rub with kitchen paper
Manuale_FRYTOP_elettrico_31877000_21_01_2009.indd 26
Manuale_FRYTOP_elettrico_31877000_21_01_2009.indd 26
ENGLISH
or a soft cloth. Do not use sponges or any type of
abrasive products. As well as corrosive detergents
such as oven spray or stain removers.
3) Rinse the surface well and dry with a soft cloth or kitchen
paper.
We recommend cleaning after every use.
COMPONENT REPLACEMENT (SPARE PARTS)
Use only original spare parts supplied by the
manufacturer.
All maintenance must be carried out by a qualifi ed person.
Complete appliance service at least once a year. We
recommend subscription to our maintenance agreement.
LONG PERIODS OF INACTIVITY OF THE APPLIANCE
If the appliance is not used for long periods of time, please
observe the following:
1) switch off the isolator switch to disconnect the mains.
2) clean the equipment and the surrounding areas
properly
3) pour a small quantity of cooking oil on the stainless steel
surfaces and on the griddle
4) carry out all maintenance operations
5) cover all appliances with a suitable material and leave
few openings to allow air to circulate
WHAT TO DO IN THE EVENT OF FAILURE
In the event of a failure, disconnect the appliance immediately
from the mains and contact for Service Assistance.
26
21/01/2009 14.06.30
21/01/2009 14.06.30