Part Names And Functions Of The Remote Controller - Toshiba MCY-MHP0506HT Manual Del Propietário

1FAN_OM_EHV0000101-01.book Page 6 Thursday, September 13, 2018 5:10 PM
Floor standing type
Discharge louver
Controls discharge air directions.
Earth screw
Equipped on the electrical
control box.
Air filter
Filters out dust.
Air intake
Air in the room is taken in
through here.
EN-11
3
Metal fittings
Vertical louver
Automatically directs the airflow horizontally
This remote controller can control up to 8 indoor units.
at regular intervals.
Drain pan
All indicators are displayed in the display example below.
Water collected here is drained out through
Actually, only the selected options will be displayed.
the drain pipe.
•
• The initial settings progress while
Metal fittings (left / right)
The LCD may temporarily be blurred due to static electricity.
1
2
3
4
5
– 6 –
Part Names and Functions of the Remote
Controller
Display section
blinks on the display of the remote controller the first time the power
switch is turned on.
is blinking. Start to use the remote
controller after has disappeared.
NOTE
1 7 8 9
2
3
4
5
6
22
14
15
17
SETTING indicator
Displayed when setting the timer or other functions.
Operation mode indicator
Indicates the operation mode selected.
Error indicator
Displayed when the protective device activates or
an error occurs.
Time display
Indicates time concerning the timer.
(Indicates an error code when an error occurs)
Timer mode indicator
Displays the timer mode.
Owner's Manual
Display
section
Operation
section
18
19
16
10
20
11
21
12
13
6
Filter indicator
Reminder to clean the air filter.
7
TEST run indicator
Displayed during test run.
8
Louver position display
Indicates the louver position.
* Only for 4-way cassette, 1-way cassette, 2-way
cassette, ceiling types
EN-12