Astralpool Corail protect Manual De Uso página 95

The alignment process is carried out in the vertical and horizontal planes by orienting the
cell directly
Optical sighting system
4.7.2 Electronic alignment of the beacons
Reconnect the battery and reconnect the system to the power supply
Note: The beam control board present on a beacon is always associated with the receiver cells fitted on
that beacon.
1. Connect the barrier to the power supply (on the transmitter and receiver sides)
2. Keep the ALIG.T pushbutton pressed down on the beam control board (see figure) placed on the
receiver side of the barrier( for at least 2 seconds) to switch to alignment adjustment mode. The
switchover to alignment mode is confirmed by a series of 5 beeps followed by a flash of light on
the LED showing that the beam being aligned is beam Nº1 (lower beam)
Buzzer
Led
Alig.T
versión 1-2008
26