Astralpool Corail protect Manual De Uso página 96

4.7.2.1 Optimization of the transmitter cells
3. Adjust the transmitter cell for the barrier undergoing alignment so as to obtain a succession of
beeps with the fastest frequency possible. When the alignment is at tis optimum level, the
audible signal should be continuous.
4. Move on to the upper beam by pressing the ALIG.T pushbutton briefly (for less than one
second). The number of the beam undergoing alignment is shown by a number of times the LED
flashes (once for the lower beam, and twice for the upper beam).
Buzzer + LED
4.7.2.2 Optimization of the receiver cells
5. Repeat stages 4 abd 5m with the receiver cells
Buzzer + LED
Depending on local weather conditions, it may prove difficult to obtain a continuous signal at a distance
of over 20 m.
4.7.2.3. Return to barrier detection mode
6. Keep the pushbutton ALOG.T pressed down. The fact of exiting the alignment mode is
confirmed by an initial series of beeps showing the channel setting on the beacon, followed by a
long beep.
7. Test correct operation of the barrier by cutting off each of the beams. When one of the beams is
cut off, the LED must come on for at least 2 seconds.
8. Repeat all these operations for each barrier installed
Beam control board
Beam control board
Audible signal
Continuous signal
Quick beeps
Slow beeps(about 1 per
second)
Alignment status
Excellent
Good
Poor
versión 1-2008
27