Setting The Barking Detection Sensitivity; Checking/Replacing Battery - Num'axes Iki Voice Manual De Instrucciones

Setting the barking detection sensitivity

Setting the barking detection sensitivity is a very important preliminary operation. In fact, this setting
determines the correct operation of the product.
It ensures detection of any barking but helps avoids unnecessary detection.
The detection must therefore be sufficiently sensitive but not overly sensitive.
In the factory, detection sensitivity is set on the position "maximum sensitivity".
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as follows:
- Remove the 2 screws from the battery cover with the supplied screwdriver.
- Remove the battery cover.
- Carefully turn the setting screw (situated at the right side of the battery cover) according to the
sensitivity you wish (See. Diagram 6)
Caution: the adjustment system has a stop for the minimum sensitivity and a stop for the maximum
sensitivity (maximum 3/4 turn). Turn delicately and without forcing with the supplied screwdriver.
- Replace the battery cover taking care to insert first the little pin at the bottom of the battery
cover (See diagram 3).
- Retighten moderately the 2 screws.
Listening/recording of vocal messages

Checking/Replacing battery

When the battery is too weak for the operation of the product, sound beeps indicate it when you turn
on or off your collar : a series of close sound beep are emitted.
When the battery is really too weak, the product works under safety mode, which means that it is out
of use. You need to replace the battery by a new battery of the same type (3 Volt CR2450 lithium battery)
following the procedure explained in the paragraph § Fitting the battery.
MINIMUM sensitivity
Diagram 6
Gb - 18
MAXIMUM sensitivity
MEDIUM sensitivity