Checking/Replacing Battery Of Remote Control - Num'axes CANICOM 200 FIRST Manual De Instrucciones

Checking/replacing battery of remote control

To check the condition of the battery, observe the indicator light located on the front of the remote
control. If the indicator light flashes green 3 times when you press a button, the battery is weak.
Performance (radio range) of the remote control deteriorates as battery becomes weak. You
should soon replace the battery.
Remove the old battery and replace it with a new one (3-V Lithium CR 2430) as follows:
- On the back of the remote control, unscrew the screw and remove the battery cover.
- Remove the old battery.
- Insert the new battery (3-V lithium CR 2430) making sure the polarity "+" noted on the battery is
visible (ref. Diagram 5).
- Put the battery cover back in place and retighten the screw.
- Check the remote control operates correctly: Press a button: if the indicator light located on the front
of the remote control flashes green, the battery is properly inserted. If the indicator does not light,
remove the battery and check the polarity before inserting it once again (ref. Diagram 5: "+" noted on
the battery must be visible).
« + » of the battery
must be visible
CANICOM_200_First_indice_K 2017.indd 21
Gb - 21
Diagram 5
17/05/2017 11:54