Metabo HPT CJ 36DA Manual De Instrucciones página 16

English
7. Cutting stainless steel plates
This Jig Saw can cut stainless steel plates by using
No. 97 blade (sold separately). Carefully read
"Concerning cutting of stainless steel plates" for
proper operation.
8. Splinter guard
CAUTION
Be sure to switch OFF and disconnect the
battery from body.
Using the splinter guard when cutting wood materials
will reduce splintering of cut surfaces.
Using the provided Allen wrench, tighten the bolts in
the lower area of the base, moving the base as far
forward as possible. (See Fig. 14)
Base bolt
Base
Insert the splinter guard in the space on the base, and
push it completely. (see Fig. 15)
Splinter
guard
9. Sub base (sold separately)
CAUTION
Be sure to switch OFF and disconnect the
battery from body.
Used for curved cutting of pieces such as arcs and
circles. Makes the task easier by eliminating any
snags that may occur between the rear of the base
and the material.
16
Allen wrench
Fig. 14
Base
Blade
Fig. 15
Fit into position after hooking the sub base to the tip
of the base. (Fig. 16)
To detach, pull up.
NOTE
When the sub base is attached, the blade's protrusion
from the material being cut will be reduced by 3mm.
When the blade has been moved down to the lowest
point, check to make sure that it is protruding from the
material.
10. Attaching and detaching the chip cover (Fig. 17)
Chip cover's catches
Chip
cover
Slots
Guide section
WARNING
To prevent accidents when attaching or detaching
the chip cover, make sure the unit is switched off
and pull out the battery.
NOTE
The chip cover cannot be attached with the base in
an inclined state.
(1) Position the unit at a right angle to the surface
(0-degree incline).
(2) Holding the chip cover's guide section open by hand,
push into the main unit.
Sub base
Base
Fig. 16
Fig.17