Connecting With Cleaner - Metabo HPT CJ 36DA Manual De Instrucciones

CONNECTING WITH CLEANER

By connecting with cleaner (sold separately) through dust
collection adapter and adapter (sold separately), most of
dust can be collected. (Fig. 35)
Base
Dust collection
adapter
(1) Loosen the base bolt allen wrench attached on base.
(Fig. 25)
(2) Move the base fully forward, and tighten the base bolt
again. (Fig. 25)
(3) Attach the chip cover (Fig. 17)
(4) Connect the dust collection adapter with adapter.
(Fig. 35)
(5) Connect the adapter with the nose of cleaner.
(Fig. 35)
(6) Insert dust collection adapter into the rear hole
of the base until the hook catches in the notch.
(Fig. 36)
(7) Press the hook to remove the dust collection adapter.
Hook
Rear
Base
Dust collection
hole
adapter
Adapter
Nose
Cleaner
Fig. 35
Notch
Adapter
Fig. 36
English
23