Personnel Qualifications; Safety Instructions In This Document - Aventics ED07 Instrucciones De Servicio

Type of risk
Consequences
Precautions
AVENTICS
2.3

Personnel qualifications

Assembly and commissioning require basic electrical and
pneumatic knowledge, as well as knowledge of the appropriate
technical terms. Assembly and commissioning may therefore only
be carried out by qualified electrical or pneumatic personnel or an
instructed person under the direction and supervision of qualified
personnel. Qualified personnel are those who can recognize
possible hazards and institute the appropriate safety measures
due to their professional training, knowledge, and experience, as
well as their understanding of the relevant conditions pertaining to
the work to be done. Qualified personnel must observe the rules
relevant to the subject area.
2.4

Safety instructions in this document

In this document, there are safety instructions preceding the steps
whenever there is a danger of personal injury or damage to the
equipment. The measures described to avoid these hazards must
be observed.
Safety instructions are set out as follows:
SIGNAL WORD
Safety sign (warning triangle): draws attention to the risk
Signal word: identifies the degree of hazard
Type of risk: identifies the type or source of the hazard
Consequences: describes what occurs when the safety
instructions are not complied with
Precautions: states how the hazard can be avoided
| ED07 | R41400766–BDL–001–AB 45
For your safety