Metabo HPT Multivolt CB 3612DA Manual De Instrucciones página 18

English
○ In Standard Mode, the circumferential speed or
the band saw blade can be freely set from 1 to 5
on the dial.
On the dial, 1 is the lowest speed and 5 is the
highest speed.
In Standard Mode, the circumferential speed that
is set with the dial is maintained even when the
load changes.
○ In AUTO Mode ("A" on the dial), noise can be
reduced and the duration of operation can be
extended by lowing the circumferential speed
when there is no load.
In AUTO Mode, if a load is applied during operation,
the circumferential speed is automatically
increased. (Equivalent of 5 on the dial)
Additionally, if the load becomes lighter after
cutting is completed, the circumferential speed
is automatically decreased, reducing power
consumption when there is no load.
Table 5 Operating Speed
Mode Dial
1 Low Speed
2
Standard
3
Mode
4
5 High Speed 640 SFPM (195 m/min)
AUTO Mode*
* Circumferential speeds may vary from those stated above depending on operating conditions.
7. Replacing the band saw blade
WARNING
● When replacing the band saw blade, be sure to
switch off the power and remove the battery from
the cordless tool.
● Use caution when changing or inspecting the
band saw blade as it may sometimes spring out.
CAUTION
● Wear gloves when changing the band saw blade.
● The band saw blade is hot immediately after
operation. Remove it only after it has cooled.
18
Band saw blade
circumferential speed
(guideline)
200 SFPM (60 m/min)
305 SFPM (93 m/min)
417 SFPM (127 m/min)
528 SFPM (161 m/min)
395 SFPM (120 m/min)
(Idle operation)
A
640 SFPM (195 m/min)
(Cutting operation)
Dial for setting
band saw blade
circumferential
speed
Diffi cult-to-cut materials such as stainless steel
and alloys
Steel materials
(Thick materials including cylindrical rods,
shaped steel, and steel pipe)
(Thickness of 0.18" (4.6 mm) or more)
Steel materials
(Thin materials including steel pipe)
(Thickness of 0.18" (4.5 mm) or less)
Steel materials
(Thin materials including steel pipe)
(Thickness of 0.18" (4.5 mm) or less)
● Verify that there are no nicks, cracks, or other
abnormalities on the band saw blade before
installing it.
● Wipe off any oil or grime adhering to the band
saw blade before installing it on the blade
pulleys.
Additionally, wipe off any shavings or grime
adhering to the blade pulley rubbers.
If a band saw blade that has oil or grime adhering
to it is installed on the blade pulleys, the band
saw blade may slip or come loose.
● When installing the band saw blade, do not twist
or bend its joint.
Doing so may damage the band saw blade.
Fig. 15
Uses
Bi-Metal