Metabo HPT Multivolt CB 3612DA Manual De Instrucciones página 27

Symptom
Cutting takes a long time
There are large vibrations
during cutting
The blade edge frequently
becomes chipped
2. Charger
Problem
The charge indicator lamp is
rapidly fl ickers purple, and
battery charging doesn't
begin.
The charge indicator lamp
blinks red, and battery
charging doesn't begin.
Battery usage time is short
even though the battery is
fully charged.
The battery takes a long
time to charge.
Possible cause
The band saw blade is facing the wrong
direction
Direction of rotation
The band saw blade operating speed is
not appropriate for the workpiece
The band saw blade is worn away
The remaining battery supply is low
The band saw blade edge is chipped
The band saw blade operating speed is
not appropriate for the workpiece
The unit is being pressed too hard during
cutting
The band saw blade has impacted against
the workpiece
The workpiece has moved during cutting
The band saw blade operating speed is
not appropriate for the workpiece
Possible Cause
The battery is not inserted all the way.
There is foreign matter in the battery
terminal or where the battery is attached.
The battery is not inserted all the way.
The battery is overheated.
The battery's life is depleted.
The temperature of the battery, the
charger, or the surrounding environment is
extremely low.
The charger's vents are blocked, causing
its internal components to overheat.
The cooling fan is not running.
Remedy
Install the band saw blade correctly.
(See "7. Replacing the band saw blade")
Direction of rotation
Select the correct band saw blade
operating speed.
(See "6. Adjusting operating speed")
Replace the band saw blade.
Charge the storage battery.
Replace the band saw blade.
Select the correct band saw blade
operating speed.
(See "6. Adjusting operating speed")
Cut using the unit's own weight or while
pressing gently.
Bring the band saw blade near the
workpiece slowly and gently begin cutting.
Fasten the workpiece fi rmly with a vice, etc.
Select the correct band saw blade
operating speed.
(See "6. Adjusting operating speed")
Possible Solution
Insert the battery fi rmly.
Remove the foreign matter.
Insert the battery fi rmly.
If left alone, the battery will automatically
begin charging if its temperature
decreases, but this may reduce battery
life. It is recommended that the battery be
cooled in a well-ventilated location away
from direct sunlight before charging it.
Replace the battery with a new one.
Charge the battery indoors or in another
warmer environment.
Avoid blocking the vents.
Contact a metabo HPT Authorized
Service Center for repairs.
English
27