Astralpool COMBO 22439 Manual De Instrucciones Y Funcionamiento página 2

IMPORTANT: This instruction manual contains essential information regarding safety measures to be taken when installing and starting-
up. Therefore, both the installer and the user must read the instructions before assembly and start-up.
"For maximum performance of your Compact Filtration Unit, it is advisable to follow the instructions indicated below".
1. CHECK THE PACKING CONTENTS
The Combo filtration unit is packed in 1 box with the following contents: (Fig.1) (Pag. 55)
a. Front module
b. 2 DIN 571 M8x50 screws with corresponding washers and plugs for concrete.
c. 2 rubber pads.
d. Filtration equipment box
e. Filtration box drain
2. GENERAL FEATURES
The Combo filtration unit is a filtering system for swimming pool water, consisting of two basic elements: the front module which is placed on
the wall of the swimming pool and a filtration unit which contains the pump, filters and the control panel. These elements are connected to
each other by means of 3 conduits and 1 electric cable.
Description of the components (Fig. 2 y 3) (Pag. 55)
1. Body of the Front module
2. Lamp. In code 22440
3. Access cover to skimmer
4. Hinged cover of the skimmer
5. Connection for cleaning hose
6. Nozzle to drive filtered water
7. Body of the filtration box
8. Top cover of the box
9. Pump
10. Filter
11. Three-way valve for pool cleaner
12. Selector valve for filtering, emptying, washing, rinsing and recirculation.
13. Control panel
14. Transformer. In code 22440
15. Lamp cable packing gland. In code 22440
16. Pneumatic pushbutton. In code 22440
The compact filtration system can perform four functions with one single unit:
• Filters swimming pool water.
• Provides a connection for a pool cleaner.
• Empties the pool.
• Provides Swimming pool lighting. In code 22440.
The advantage of using compact equipment is that installation is minimum. A power supply and two drains are all that is needed.
The compact filtering equipment meets standard: UNE 20-460-93
Under no circumstances will the manufacturer be held responsible for the assembly, installation or incorporation of electrical components
that have not been factory fitted.
3. INSTALLATION AND ASSEMBLY
To install, follow the steps below:
3.1. INSTALLATION OF THE COMBO FRONT MODULE
• Place the Combo in the most suitable position bearing in mind the direction of prevailing wind. The Front module of the Combo should be
located in an area where dirt accumulates (leaves and other floating particles), meaning that it should be placed centrally on the wall which
is against the direction of the prevailing wind (Fig. 4) (Pag. 55) .
• Having decided on the most suitable position for the Front module, the wall should then be prepared for installation. In a new pool, plan to
leave the crown as specified below. In an existing pool, part of the crown will have to be removed to leave it in the following condition:
Part of the pool wall should be left free from the crown (82 cm), so that the Front module and its fairing can be incorporated. The water
level of the pool should cover half the hinged gate of the skimmer (it is recommended to leave a distance of 12 cm between the water level
and the base where the Front module rests) (Fig. 5) (Pag. 55) . The surface on which the equipment rests should be completely horizon
tal and flat so that the equipment is exactly aligned to the wall.
-1-
ENGLISH