Replacing The Lamp; Closing The Door - AEG SCT51800S0 Manual De Instrucciones

Problem
Water flows on the
ground.
The temperature in the ap-
pliance is too low.
The temperature in the ap-
pliance is too high.
The temperature in the re-
frigerator is too high.
The temperature in the
freezer is too high.

Replacing the lamp

1. Switch off the appliance.
2. Press on the rear hook and at the same
time slide the cover in the direction of
the arrow.
3. Replace the lamp with one of the same
power and specifically designed for
household appliances. (the maximum
power is shown on the lamp cover).
4. Install the lamp cover by sliding it into
its original position.
5. Switch on the appliance.
6. Open the door. Make sure that the light comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
Possible cause
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative tray
above the compressor.
The temperature regulator is
not set correctly.
The temperature regulator is
not set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at
the same time.
There is no cold air circulation
in the appliance.
Products are too near to each
other.
What to do if...
Solution
Make sure that products do not
touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
37