Beem Café Joy V2 Manual De Instrucciones página 37

EN
Installing the strainer insert
NOTE
► Select the flat strainer insert (13a) to
make a cup of espresso (image B1).
► Select the deep strainer insert (13b)
to make two cups of espresso at the
same time or for a double espresso.
Turn the nib on the side of the strainer
‹
insert (13) towards the handle (11)
and insert the strainer (12) into the
holder (image B 2).
After inserting, turn the strainer (13)
‹
a quarter-turn to the left or right. The
nib prevents the strainer insert from
falling out.
Removing the strainer insert
After using, empty the strainer insert
‹
(13) as described in the section Emp-
tying/cleaning the strainer insert
(page 40).
Turn the strainer insert (13) so that
‹
the nib on the wall of the strainer
insert is pointing towards the handle
and lift the strainer insert (13) out of
the holder (12).
BEEM - Elements of Lifestyle
Installing the strainer holder
NOTE
► The following symbols refer to
the mark (6) on the brewing unit
.
Hold the strainer holder (12) using the
‹
handle (11) under the
brewing unit (6) and push the strained
holder into the brewing unit from be-
low (image D1).
NOTE
► Take care not to tilt the strainer
holder.
Turn the handle (11) of the strainer
‹
holder (7) to the right until the handle
is under the symbol
Removing the strainer holder
Turn the handle (11) of the strainer
‹
holder (12) to the left until the handle
is under the symbol
unit.
Take the strainer holder out of the
‹
strainer holder from below.
Café Joy V2
symbol on the
(image D2).
on the brewing
35