COOK Medical H-30 Manual Del Usuario página 35

5
Fiber Aperture/
Bulkhead Connector
5. Unscrew the blast shield and slide it up, out of its
mounting slot. The thumbscrew attached to the
blast shield is a captive screw, so it will not fall off of
the blast shield.
7. After replacing the blast shield, close the top panel. The blast shield can only be inserted and the thumbscrew
attached in one orientation.
8. Engage the bayonet latch by pushing it in.
9. Loosely tighten the bayonet latch locking screw.
10. Reattach the decorative strip at the top of the rear panel.
Cook Medical © 2012
Blast Shield
Return to Table of Contents
6
Blast Shield
Removed
6. The blast shield can be inspected (for soiling or
debris), and if damaged, should be replaced.
Chapter 6
Maintenance
1-34