Brew Group - Saeco SYNTIA Sup 037DRC Instrucciones De Uso

• It is recommended to clean the water
tank daily.
- Remove the small white fi lter in the
water tank and wash it under running
drinking water.
- Reposition the small white fi lter in
its housing by gently pressing and
turning it at the same time.
- Fill the water tank with fresh drinking
water.
• Empty and clean the drip tray daily.
Perform this operation also when the
fl oat is raised.

Brew Group

• The brew group must be cleaned at
least once a week.
• Turn off the machine by pressing the
ON/OFF button and remove the plug
from the socket.
• Remove the dregdrawer. Open the
service door.
• To remove the brew group, pull it by the
handle and press the «PUSH» button.
The brew group must be washed only
with lukewarm water, no detergent/
soap is necessary.
• Wash the brew group with lukewarm
water and carefully clean the upper
fi lter.
• Thoroughly wash and dry all the parts
of the brew group.
• Thoroughly clean the inside of the
machine.
• Make sure that the brew group is in
rest position. The two references must
match.
• The lever on the rear part of the brew
group must be in contact with the base.
Press the "PUSH" button to make sure
that the brew group is in the correct
position.
Lubricate the brew group af-
ter approximately 500 brew-
ing cycles. The brew group lubricant
may be purchased at authorized
service centers.
• Lubricate the brew group guides using
the supplied lubricant only.
• Apply the lubricant evenly on both side
guides.
• Insert the brew group in its seat until it
locks into place WITHOUT pressing the
"PUSH" button.
• Insert the dregdrawer. Close the service
door.
• 33 •