JVC DLA-F110 Manual De Instrucciones página 52

3
Adjustments and settings in the menu (continued)
Off
1 Hour
2 Hours
3 Hours
4 Hours
High Altitude Mode
On
Off
Communication
Terminal
RS-232C
LAN
Network
Lamp Reset
[5-1] Network
DHCP Client
On
Off
IP Address
Subnet Mask
Default Gateway
MAC Address
Set
[6] Information
Displays upon HDMI/COMP. input
Input
Source
Deep Color
Lamp Time
Displays upon PC input
Input
Resolution
H Frequency
V Frequency
Deep Color
Lamp Time
52
This manual downloaded from http://www.manualowl.com
Operation
Power is not turned off.
Power is turned off automatically after 1 hour.
Power is turned off automatically after 2 hours.
Power is turned off automatically after 3 hours.
Power is turned off automatically after 4 hours.
Set to use at low pressure locations (900m above sea level).
Settings: On, Off
Set.
Do not set.
Sets the used control terminal. It is not possible to use it at the same time.
Settings: RS-232C, LAN
Sets the RS-232C terminal.
Sets the LAN terminal.
It is displayed, if the setting of the "Communication terminal" to the submenu "[5-1]
Network" is set to "LAN".
Reset of the lamp use time to "0".
Sets the DHCP client.
Settings: On, Off
Obtains automatically an IP address from within the connected network's DHCP server.
* The automatic retrieval starts with the "Set" within the menu.
The network settings are being done manually.
Sets the IP address.
Sets the subnet mask.
Sets the default gateway.
Displays the MAC address of the unit.
[5-1] Reflects the network setting.
Displays video image input terminal.
Displays the name of the input source.
Displays the color bit depth concerning an input video image signal.
* When you input YCbCr (4:2:2), it is not displayed.
* When there is information about DeepColor from the source device, it is displayed.
Displays the lamp use time.
Displays video image input terminal.
Displays image resolution.
Displays the H Frequency.
Displays V Frequency.
Displays the color bit depth concerning an input video image signal.
* When you input YCbCr (4:2:2), it is not displayed.
* When there is information about DeepColor from the source device, it is displayed.
Displays the lamp use time.
[Off]
[RS-232C]
[Off]
[192.168.0.2]
[255.255.255.0]
[192.168.0.254]