Display Setup - JVC DLA-F110 Manual De Instrucciones

Adjustments and settings in the menu (continued)

[4] Display Setup

Back Color
Blue
Black
Menu Position
Menu Display
15 sec
On
Line Display
5 sec
Off
Source Display
On
Off
Lamp Replacement
Display
On
Off
Logo
On
Off
[5] Function
Trigger
Off
On (Power)
On (Anamo)
Off Timer
This manual downloaded from http://www.manualowl.com
Sets the color of the background, which is displayed without an input signal.
Settings: Blue, Black
Sets the background color to blue.
Sets the background color to black.
Sets the picture position of the menu. Please set to your preferred position Navigate the
menu by pressing the left or right keys when you have selected an item. Moreover, if
one presses the button [OK], an image illustration appears at the position of the menu.
The highlighted position in the illustration moves by use of the left and right keys. If one
presses [OK], the menu moves to the highlighted position.
If you press the key to the right, the menu will move starting from the higher left -> the
higher right -> the center -> the lower left -> the lower right and then back to the higher
left. By pressing of the left key, the menu moves in the opposite direction.
Sets the time for the menu to be displayed.
Settings: 15 sec, On
If there is no menu operation for 15 seconds, the menu display vanishes.
Display always.
Configures if input is displayed or not when input is switched.
value: 5 sec, Off
Displays for 5 seconds.
Not displayed.
Configures whether or not to display the signal, when the input is switched.
Settings: On, Off
Display.
Not displayed.
Configures whether an indicator is displayed when it is time to replace the
lamp.
Settings: On, Off
Display.
Not displayed.
Configures whether or not to display the "D-ILA" logo upon activation.
Settings: On, Off
Displayed for 5 seconds.
Not displayed.
Configures 12V output to an external screen equipped with a trigger function.
Settings: Off, On(Power), On(Anamo)
No output.
When turned on, control signals (12V) from the trigger terminal are emitted.
If you turn off the power, the output of the control signal stops.
During standby mode, an output will occur if the OPERATE button is pressed.
After cooling, the output stops when you go back to standby.
Control signals (12V) are emitted when the Anamorphic mode is set from "Off" to "A" or
"B". If the Anamorphic mode is set to "A" or "B", the operation in this state equals "On
(Power)".
Sets Off Timer function and its time.
* If there are no operations, the unit powers off automatically.
* It powers off automatically even while projecting an image.
Settings: Off, 1 hour, 2 hours, 3 hours, 4 hours
ENGLISH
[Blue]
[the higher left]
[On]
[5 sec]
[On]
[Off]
[On]
[Off]
[Off]
51