Installation - JVC LT-40HG60U Instrucciones De Funcionamiento

Installation

Front panel
1: Remote Control Sensor.
2: Power Indicator LED:
BLUE POWER ON.
RED STANDBY.
3: Side buttons
REAR AV Connections
AC-INPUT
VIDEO/Y
100-240V~ 50/60Hz
All the terminals are(from left to right): AC POWER INPUT, VIDEO, YPbPr INPUT, AUDIO
INPUT, COAXIAL OUTPUT, HDMI3, SCART.
Note: VIDEO and YPbPr share one audio channel.
If the picture is ahead of sound, this lip sync problem can be solved with your home theatre
system. Please change the settings as appropriate.
REAR AV Connections(SIDE)
USB HDMI2
All the terminals are(from left to right):
USB, HDMI2, HDMI1(ARC), HEADPHONE, CI, PC AUDIO, VGA, RF.
Note: 1.When HDMI 1, 2 and 3 ports get DVI signal, the audio signal receives from the PC
Audio channel.
2.Insert the plug of the earphone into the earphone jack on the unit HEADPHONE.
The speakers are now muted.
HDMI ARC (Audio Return Channel)
The ARC function allows you to send audio signal from your ARC-compliant TV to
ARC-compliant audio devices (e.g.home theatre) without the need to connect any audio cable.
(
ex. Coaxial , Optical digital audio cable, or analog Audio cable)
To enjoy the ARC function:
1. Make sure your ARC-compliant audio devices are connected by an HDMI 1.4 cable to the
HDMI 1(ARC)port of your ARC-compliant TV.And open the ARC function of ARC-compliant audio
devices.
2.Adjust TV : press MENU go to OPTION, set HDMI CEC and HDMI ARC both ON.
3. Then, just use your TV remote control to adjust the volume output (VOL +/- and MUTE)
of the connected audio device.
Note: if the ARC-compliant audio devices do not support sound that TV outputs, such as Dolby
Digital , or Dolby Digital Plus, then ARC function will not work and there may be no sound from
ARC-compliant audio devices, in this case, please set SPDIF to PCM.
3
1
2
30 30
FREEZE
EPG
VOL CH
Pb Pr L R COAXIAL OUTPUT
COMMON INTERFACE(CI)
HDMI1(ARC)
HEADPHONE
KEY BOARD
1. SOURCE: Displays the input source menu;
press repeatedly to move down the menu or press
"CH+" or "CH-" to select the required source.
2. MENU: Display main MENU.
3. CH+/CH-: In TV mode, press "CH+" or "CH-" to
change the channel up and down. In MENU mode,
press "CH+" or "CH-" to select items.In standby
mode, press "CH+" or "CH-" to turn on the TV.
4. VOL+/VOL-: Adjust sound level. In MENU mode,
press "VOL+ " or "VOL- " to adjust the item that
you selected.
5. STANDBY: Press this button to turn the unit ON
from STANDBY mode. Press it again to turn the set
back to STANDBY.
HDMI3
PC AUDIO
SOURCE
MENU
CH+
CH-
VOL+
VOL-
STANDBY
SCART
VGA R F
EN
9