SYNOPTIC PANEL
key to set the ambient temperature desired or to enter
the menu (set ambient temp.)
key to set the stove power
(set power)
key to switch on/off or confi rm exit from menu
indicates the chronothermostat was programmed for
automatic and timed switch on
MENU DESCRIPTION
• To access the menu press the
switches off).
Pressing the
key or the
menu:
- M1: Set clock
- M2: Set chrono
- M3: Language
- M4: Stand-by
- M5: First load
- M6: Status
- M7: Technical calibration (TSC)
- M8: Pellet type (TSC)
- M9: Exit
• To confi rm the desired menu press the
• To go back to the previous menu press the
seconds.
• To exit the menu press the
SWITCH ON/SWITCH OFF
To switch on/switch off the stove, press the
seconds.
Led on
stove on
Led fl ashing stove on or in alarm mode
Led off
stove off
INSTRUCTIONS FOR USE
key for 2 seconds (the led
key scrolls the following
key.
key for 3
key for 6 seconds.
key for 3
indicates an alarm condition
indicates functioning of the pellet gearmotor
indicates fan functioning
indicates functioning of the glow plug
OPERATION
The stove has two operating modes:
- MANUAL:
In MANUAL operating mode, the power is set on which the
stove works, independent of the temperature of the premises in
which the stove was installed.
To select MANUAL operating mode,
press the key
(the led switches on).
Pressing the key
you can increase the temperature until the
display shows the writing 'MAN' (over 40°).
- AUTOMATIC
In AUTOMATIC operating mode, you can set the objec-
tive temperature to obtain in the premises where the stove is
installed.
The stove, autonomously, on reaching the desired ambient
temperature (SET AMBIENT TEMPERATURE) will set to
modulation, going to power 1.
To set the ambient temperature, press
on), the current working temperature will be displayed,
using the key
or the key
ture to reach your desired temperature.
Ventilation is always linked to power in use, therefore it cannot
be changed.
- 115
-
, (the led switches
you can change the tempera-