Installation And Connection; Energy And Environment Tips; Saving Energy; Environmentally-Friendly Disposal - NEFF H11GE60N0 Instrucciones De Uso

Installation and connection

This appliance is intended for domestic use only.
This appliance is only intended to be fully fitted in a kitchen.
Please observe the special installation instructions.
The appliance can be fitted in a 60 cm wide wall cabinet (min.
30 cm deep and 85 cm off the floor).
The appliance is fitted with a plug and must only be connected
to a properly-installed earthed socket. The fuse protection must
be rated at 10 amperes (L or B circuit breakers). The mains

Energy and environment tips

Here you can find tips on how to save energy when baking and
roasting and how to dispose of your appliance properly.

Saving energy

Only preheat the oven if you are asked to in the recipe or in the
tables in the instruction manual.
Use dark-coloured, black-coated or enamelled baking tins.
They absorb the heat particularly well.
Always keep the appliance door closed when cooking.
If you are baking more than one cake, it is best to bake them
one after the other.The cooking compartment will still be warm.
This can reduce the baking time for the second cake.
For longer cooking times, you can switch the oven off 10
minutes before the end of the cooking time and use the
residual heat to finish cooking.

Environmentally-friendly disposal

Dispose of packaging in an environmentally-friendly manner.
This appliance is labelled in accordance with
European Directive 2012/19/EU concerning used
electrical and electronic appliances (waste electrical
and electronic equipment - WEEE). The guideline
determines the framework for the return and recycling
of used appliances as applicable throughout the EU.
voltage must correspond to the voltage specified on the rating
plate.
The socket must be installed and the power cable replaced by
a qualified electrician only. If the plug is no longer accessible
following installation, an all-pin disconnecting device must be
present on the installation side, with a contact gap of at least
3 mm.
Multiple plugs, plug bars and extension leads must not be
used. Overloading can result in a risk of fire.
21