Adjusting Parameters - LGB 10345 Manual De Instrucciones

Operation
Place a train on the track between the stations. Adjust
the throttle to a medium setting. After a short pause,
the train will start and proceed to one station. When
it crosses the insulated track section, it will slow
to a stop. After the preset wait time has elapsed, it
will slowly accelerate in the opposite direction and
proceed to the other station. The train will shuttle
between the stations until the power is switched off.
12
ADJUSTING PARAMETERS (BOTH MODES)
Adjusting the station stop time
Beschl. Wartezeit
The time for a stop at a station is set by means of the
„Pause" switch and the „Wait Time" setting controller
on the circuit board.
• Set the range of the time for the stop at the right
switch:
„short" short (approximately 2 – 60 seconds)
„long" long (approximately 1 - 8 minutes)
• Turn the setting controller to set the time for the
stop within these ranges.
• Turn the setting controller to set the acceleration
after the stop (1 – 8 seconds).
1 kurz
2 lang