LGB 10345 Manual De Instrucciones página 13

Adjusting the acceleration and braking
The acceleration and braking are set with the
"Delay" adjustment knob on the circuit board. Turn
the adjustment knob for faster or slower acceleration
and braking. The acceleration and braking cannot be
adjusted separately.
Hints:
• In mode 1 "Basic", only the acceleration can be
adjusted. Braking always is abrupt when the train
crosses the insulated track sections.
• New settings for station stop time and acceleration/
braking will take effect after the next station stop. It
is not necessary to turn off the power.
Overload Protection
The 10345 is protected against short circuits and
overloading. If an overload current of more than
3 amps occurs, the unit will switch off for 10 seconds.
However, this overload protection functions only when
using a power supply with an output of 3 amps or
more. After 10 seconds, the unit will switch on again.
When using a power supply with an output of less
than 3 amps, a short circuit will trigger the overload
protection of your LGB power supply.
Maximum current
The 10345 can be used with trains that draw up to
3 amps. If you are double-heading locos with sound
or running long trains with lighted cars, your trains
may trigger the overload protection (see Overload
Protection).
Minimum Voltage
To operate properly, the 10345 requires an input
voltage of 10 volts or more.
13