Technical Data - Zanussi ZBB28430SL Manual De Instrucciones

Problem
There is too much frost.
Replacing the lamp
Caution! Disconnect the plug from the
mains socket.
1
2
1
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".

Technical data

Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
10
Possible cause
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not set
correctly.
1. At the same time, with the fingers expand up
2. Replace the lamp with one of the same power
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the light
Height
Width
Depth
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
and down the transparent cover and unhook it
in the direction of the arrows.
and shape, specifically designed for house-
hold appliances. (the maximum power is
shown on the light bulb cover).
comes on.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1780 mm
560 mm
550 mm
22 h
230-240 V
50 Hz
Solution
www.zanussi.com