What To Do If - Zanussi ZBB28430SL Manual De Instrucciones

What to do if...

Warning! Before troubleshooting,
disconnect the mains plug from the mains
socket.
Only a qualified electrician or competent person
must do the troubleshooting that is not in this
manual.
Problem
The appliance does not op-
erate. The lamp does not
operate.
The lamp does not work.
The compressor operates
continually.
Water flows on the rear
plate of the refrigerator.
Water flows into the refrig-
erator.
Water flows on the ground.
The temperature in the ap-
pliance is too low/high.
The temperature in the re-
frigerator is too high.
The temperature in the
freezer is too high.
www.zanussi.com
Possible cause
The appliance is switched off.
The mains plug is not connected to
the mains socket correctly.
The appliance has no power. There
is no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set correctly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The product temperature is too
high.
The room temperature is too high.
During the automatic defrosting
process, frost defrosts on the rear
plate.
The water outlet is clogged.
Products prevent that water flows
into the water collector.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
The temperature regulator is not set
correctly.
There is no cold air circulation in the
appliance.
Products are too near to each other. Store products so that there is cold
Important! There are some sounds during
normal use (compressor, refrigerant circulation).
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appli-
ance to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature before
storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher/lower temperature.
Make sure that there is cold air circu-
lation in the appliance.
air circulation.
Solution
9