dirna Bergstrom bycool blue line FLAT IVECO Instrucciones De Montaje página 26

FLAT
EN
Important:
!
The evaporative air conditioner works by taking air which is brought into the cab from
the outside. The air must not become stagnant inside, as this would produce excessive
humidity. All modern vehicle cabs are fitted with air vents, so air is able to leave if
needed. For example, for the heating.
The installer must check that vents are in place, and if not, they must be installed.
The user must also regularly check that these vents are not clogged.
1
Run the power cable of the equipment to the vehicle battery, sticking the plastic supports on the rear
part of the cab and attaching it with cable ties; then with the cab folded forward pass the cable through
the lower area and fasten it with clamps and M4 screws; and as far as the battery with cable ties; the
same pitch should be used as that of the original cable. (Clean the area well before sticking the plastic
supports). On connecting the equipment to the battery this will automatically carry out a test on all its
leds, and will switch off.
Detailed instructions
about power supply installation
1
Power cable
26
®