Circuit Breakers; Draining Tanks; Draining Recovery Tank - Nobles Speed Scrub 2601 Manual Del Operador Y Piezas

OPERATION

CIRCUIT BREAKERS

The machine is equipped with (4) resettable circuit
breakers to protect machine from damage.
If circuit breakers should trip, the breakers will not
reset immediately upon tripping. Determine cause,
allow motor to cool then manually reset circuit breaker
button.
The brush motor circuit breakers may trip due to
excessive brush pressure. Reduce brush pressure.
Brush motor circuit breakers (25 amp) are located
near the charger plug.
The main (10 amp) and drive/vacuum (35 amp) circuit
breakers are located at rear of machine (Figure 18).
FIG. 18
12
Home Find... Go To..

DRAINING TANKS

FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.

DRAINING RECOVERY TANK

Drain recovery tank:
– After each use.
– Before refilling solution tank.
– When squeegee starts trailing water.
– When solution flow stops.
– When float shut-off screen, located inside
recovery tank, is activated.
– If optional ESt indicator light remains on.
ATTENTION: Do not allow foam or water to enter
float shut–off screen, vacuum motor damage will
result. Foam will not activate the float shut–off
screen.
1. Remove drain hose from holder, position hose
over floor drain and twist off drain hose plug. To
completely drain recovery tank, hinge open tank
and flip up tank support stand to rest tank on
(Figure 19).
NOTE: If using a bucket to drain machine, do not use
same bucket for filling solution tank. This will prevent
possible solution line clogs.
FIG. 19
2. Flush out out recovery tank after each use. Be
careful not to spray water into the float shut–off
screen.
3. Replace drain hose plug securely after draining
and return hose to hook.
Speed Scrubt 2601 Cylindrical Brush (12–02)