dirna Bergstrom bycool COMPACT 1.4 Instrucciones De Montaje página 16

COMPACT 1.4
EN
Connect the return air sensor 2-way box, the
10
blower 4-way box and the electronic control
cable connection 8-way box.
Position the interior air distribution panel
11
on the front studs with (1) M6 wide-rimmed
washer and (1) M6 nut on each stud. Tighten
the nuts until the interior air distribution panel
duct comes up against the unit's top foam.
Important: The interior air distribution
panel duct must come up against the
unit's upper foam in order to prevent any
leakages of air.
Ø 6 flat washer
Original
edgeband
Cabin roof
Upholstery
Original screw
Ø 20 x Ø 7 x 3 rubber washer
9
A
M6 nut
M6 nut
M6 stud
Console
11
Foam
Adjust canalisation systems against base joint
16
10
Scheme A
®