Possible Misuse; Dust Blower; Anti-Splinter Insert; Technical Data - Hilti SJT 6 Manual Del Usuario

The product is equipped with a removable connector for an optional vacuum cleaner / dust removal hose.
This connector is designed to fit standard suction hoses. In order to connect the suction hose to the product,
use of a suitable adapter may be necessary.
The tool may be operated only when connected to a power source providing a voltage and frequency in
compliance with the information given on the type identification plate.
▶ Use this product only with saw blades equipped with a T-shank.
3.3

Possible misuse

• Use of the product to cut off tree branches or to cut the trunk of a tree is not permissible.
• Use of the product to cut hazardous materials is not permissible.
• Use of the product in a damp or wet environment is not permissible.
3.4

Dust blower

The dust blower directs a jet of air toward the saw blade in order to keep the cutting line free of dust.
3.5 Stroke rate
The stroke rate can be adjusted by turning the thumbwheel. Position 1 corresponds to 800 strokes per
minute and position 6 corresponds to 3000 strokes per minute.
3.6 4 orbital-action settings
The 4 orbital-action settings allow cutting performance and quality of cut to be adjusted to suit the material
to be cut. The orbital-action adjustment lever is used to set the power tool to one of the 4 settings.
The lower the orbital-action setting, the finer and cleaner the cut edges will be. The optimum setting can be
determined by carrying out practical tests.
Status
Position 0
Position 1
Position 2
Position 3
3.7

Anti-splinter insert

The product can be equipped with an anti-splinter insert.
The anti-splinter insert helps prevent splintering on the surface of wood materials when cutting.
3.8 Items supplied
Orbital-action jig saw with saw blade, guard, dust removal adapter, anti-splinter insert, operating instructions,
hex key.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
4

Technical data

4.1

Orbital-action jig saw

When powered by a generator or transformer, the generator or transformer's power output must be at
least twice the rated input power shown on the rating plate of the power tool. The operating voltage of
the transformer or generator must always be within +5% and -15% of the rated voltage of the power
tool.
The information given applies to a rated voltage of 230 V. The data may vary in the event of deviations
from the rated voltage and for country-specific versions. Please refer to the power tool's type
identification plate for details of its voltage, frequency, current and input power ratings.
*2150300*
Meaning
No orbital action
Low orbital action
Medium orbital action
High orbital action
2150300 English 5