Preparations At The Workplace - Hilti SJT 6 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
Information on recommended minimum conductor cross-sections and cable lengths is accessible via
a link, in the form of a QR code, at the end of this document.
6

Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Fitting the saw blade
1. Disconnect the supply cord plug from the power outlet.
2. Push the saw blade (teeth facing the cutting direction) into the blade holder until it engages.
3. Grip and pull the saw blade to check that it is held securely.
6.2
Fitting the guard
▶ Push the guard onto the product from the front until it clicks into place.
6.3
Fitting the suction adapter
1. Push the suction adapter onto the base plate horizontally from the rear until both catches engage at the
side.
2. Connect the vacuum cleaner hose to the suction adapter.
6.4
Setting the orbital action
1. Determine the correct orbital-action setting for the task to be performed with the applicable saw blade.
2. Set the orbital-action adjusting lever to one of the four settings → page 5.
6.5
Adjusting the stroke rate
Determine the correct setting for the task to be performed with the applicable saw blade.
▶ Set the stroke rate regulator thumbwheel to a setting between 1 (low) and 6 (high).
6.6
Setting the cutting angle
1. Remove the suction adapter. → page 8
2. Pivot the clamping lever 90° back (toward the rear of the tool).
3. Set the desired cutting angle (0°, 15°, 30° or 45°).
4. Pivot the clamping lever 90° forward (toward the front of the tool).
▶ The base plate is clamped securely.
5. Fit the suction adapter. → page 7
6.7
Fitting the anti-splinter insert
The anti-splinter insert can be used only with the saw blades for which it is designed.
1. Disconnect the supply cord plug from the power outlet.
2. Press the anti-splinter insert into the base plate from below.
*2150300*
2
3
4
5
6
7
8
2150300
English
7

Publicidad

Tabla de contenido
loading

Tabla de contenido