Wall Mounting; Control Panel - Pur Line HOTI M50 Manual De Usuario

INSTALLATION
- The installation must be done by the service agent or similarly qualified persons
in order to avoid a hazard.
- Important! Make sure that there are no electric cables or other installations
(for example water pipes) near the drill holes. Make sure that the appliance is
securely fitted to the wall, and
with the wind outlet down.
· The appliance must be installed
at a minimum height of 2 m.
above the floor, and at least 0.25
m from the ceiling or side wall.

WALL MOUNTING

Install the appliance at 2 m. above the floor,
leaving at least a distance of 25cm from sides
to other objets or walls.
Drill 2 holes and insert the wall plugs.
Fix two screws on the wall plugs, keep the tips
of the screws out for 10mm, and hang up the
device after the screws are correctly fixed.
OPERATION
- Make sure that all packaging material has been removed from the product.
- Plug the appliance into the mains with the main switch turned off.
- Turn on the main switch, the device beeps, the operation indicator lights up, and the display shows the
default temperature, which flashes for 3 seconds.

CONTROL PANEL

2 3
1
W-Timer AUTO
6 7
Power I/W
10 11 12
ON/OFF MODE
4 5
24H Delay
8 9
II/H FAN/M
13
TIMER RECEIVER
385 mm
1. LED display
Light indicators:
2. Week timer
3. Open window detection
4. Timer 24 h
5. Delay
6. Power
7. Heating 1000W / Week
8. Heating 2000W / Hour
9. Fan / Minutes
10
Buttons:
10. ON/OFF
11. Mode
12. Timer
13. Receiver