Programming The Monitor - Fermax 6030 Manual De Instrucciones

Kit VIDEO DIGITAL
Kit VIDEO DIGITAL

PROGRAMMING THE MONITOR

Once the monitor is connected, take the following programming steps:
1. Place the J1 switch in
the PRG position. You
will hear a confimation
tone.
The time between steps 1 and 2 must be less than 2 minutes. If this period is exceeded,
set the switch in its original position and start the sequence again.
VERY IMPORTANT NOTE
The monitor will not work until it has been programmed.
Pag 28
J1
PRG
2. Press the house call
button.
confirmation tone is
heard again.
H I G H I G
H R H R
E S O E S O
C C C C
D C D C
L U T L U T
A M A M
I O N I O N
E R A E R A
P A N
& T
IL T
3. Set the switch back to its
The original position and put
the Monitor in place.
J1
PRG