Programming Access Control Functions; Codes Reset; Assigning Digit Number Length (User Codes) - Fermax MDS DIRECT Serie Manual

MDS DIRECT
MDS DIRECT

PROGRAMMING ACCESS CONTROL FUNCTIONS

• Codes RESET

Lets you erase all the codes stored in memory in one single operation. Once selected, press 'A' to
confirm, or ' ' to exit without carrying out the RESET.
M 1 2 3 4
m Co Pa De Ci
MAIN MENU
A
%
VERY IMPORTANT NOTES :
This option IS NOT REVERSIBLE.
It is advisable to carry out this operation before starting to input the Access Codes into the system.
This operation must be performed in all the MDS Direct Panels in the system.

• Assigning Digit Number Length (User Codes)

You can choose the number of digits that the system will request when an access code is entered.
Select 4, 5 or 6.
M 1 2 3 4
m Co Pa De Ci
MAIN MENU
C 1 2 3 4 5 6 7
o + - M T R D Pc
SECONDARY MENU
NOTE :
The MDS Direct Panel lets you program up to 600 access codes.
The length of the primary programming code
chosen for the system. Depending on the digit selection the code will be as follows:
- 4 digits:
A%21
- 5 digits:
A%21A
- 6 digits:
A%21A%
Regardless of the number of digits selected for the system, the secondary programming code
19025 will always have 5 digits.
C 1 2 3 4 5 6 7
1
o + - M T R D Pc
SECONDARY MENU
Reset Codes
Erasing . . .
(RESET is NOT made)
C 1 2 3 4 5 6 7
1
o + - M T R D Pc
SECONDARY MENU
M 1 2 3 4
%
m Co Pa De Ci
MAIN MENU
Reset Codes
5
Confirm
A RESET is made
%
RESET is NOT made
C 1 2 3 4 5 6 7
o + - M T R D Pc
SECONDARY MENU
Digits
6
For example:
5 Digits
may vary in line with the number of digits
A%21A%
(choosing one of them)
( A = YES )
M 1 2 3 4
%
m Co Pa De Ci
MAIN MENU
(4, 5, 6)
4
5
Pag 51