Battery Installation - Roadstar HIF-1937TUMPK Manual De Instrucciones

33. TAPE FF/EJECT BUTTON
34. TAPE SLOT-IN
35. TOP COVER MECHANISM
36. TURNTABLE
49. ON/OFF POWER SWITCH
REMOTE CONTROL
37. OPEN / CLOSE CD DOOR
38. REC: in cd or phono mode, press to active recording function.
39. REPEAT BUTTON
40. PLAY/PAUSE: in cd/usb mode, press once to start playback. Press
again to enter pause mode.
41. SKIP/SEARCH BACKWARD: press once to skip to previous track.press
& hold for search backward.
42. SKIP/SEARCH FORWARD: press once to skip to next track, press &
hold for search forward.
43. STOP: in cd/usb mode, press to stop playback or cancel the stored pro-
gram.
44. 10+ Track Button
45. 10- TRACK BUTTON
46. RANDOM BUTTON: in cd/usb mode, press to active random function.
47. DELETE BUTTON
48. PROGRAM: in CD/USB mode, press to active programming function.

BATTERY INSTALLATION

The infra-red transmitter requires 2 pcs CR-2025 size battery for operation.
CONNECTING TO POWER
Before switching on make sure that the voltage of your electricity supply is
the same as that indicated on the rating plate.
For your own safety read the following instructions carefully before attemp-
ting to connect this unit to the mains.
English 3 4 English
Press the POWER button during 1 second to turn ON the unit. Press and
hold the POWER button during 3 seconds to turn OFF the unit. When no
sound is produced, the unit will switch OFF automatically after 15 minutes.
MAINS (AC) OPERATION
This unit is designed to operate on AC 110-240V 50Hz current only. Con-
necting it to other power sources may damage the unit.
Caution: to prevent electric shock disconnect from the mains before
removing cover. No user serviceable parts inside. Refer servicing to quali-
fied service personnel.
Remove the stereo carefully from the box, retaining the packaging for future
use. Connect the plug to a mains power inlet 110 - 240V AC ~ 50 Hz.
MW/FM TUNER
Operation
1. Switch ON the Power Switch (15). The red Power Indicator (17) will light
up.
2. Select the desired frequency band with the Band Selector (14) for FM or
(12) for MW band.
3. Tune to the desired radio station by turning the Tuning control (21).
Antenna
For FM reception there is a built-in FM antenna wire (28) at the rear of

the unit. Move the wire around to obtain the best reception.
For MW reception the signals are picked up through a built-in ferrite an-

tenna. Your may have to orient the unit to obtain the best reception.
FM & FM-Stereo Reception
Stereo reception is possible when the tuned FM station is broadcasting

in stereo.
When in FM Stereo mode and the station is broadscasting in Stereo, the

STEREO indicator (19) lights up.