Össur COLD RUSH COMPACT Instrucciones De Uso página 7

sticker inside the bucket to avoid risk of overflow when closing the
cover.
3. Add chopped or cubed ice to the reservoir up to the indicated fill line
(Figure 3).
Warning: Make sure the ice level does not exceed the reference mark
on the sticker. Failure to comply will cause device overflow when
closing the lid.
4. Close the reservoir. With handle in the open position, press lid firmly
onto unit making certain that the lid is in full contact with the vessel
and the seal is engaged, then pull handle into the locked position
(Figure 4)
5. Attach the provided 12V power supply to DC power port, but do not
plug into wall (Figure 5).
6. Apply insulation barrier (not included) over the patient's skin in the
area to be treated (Figure 6).
7. Connect Cold Rush pad to hose extending from the device. To ensure
proper connection, push couplings together until they snap into place
(Figure 7).
8. Apply Cold Rush Pad over insulation barrier. The Cold Rush Pad
should never be applied directly over the patient's skin (Figure 8).
9. Plug the provided 12V power supply to wall socket (Figure 9).
10. To turn off the cold therapy device, unplug the power supply unit from
wall socket.
11. Always turn the cold therapy device off before disconnecting the Cold
Rush Pad or any hoses. To disconnect the hoses, press the release
tabs on the coupling and pull the connectors apart.
12. To open lid, press handle down to disengage lid seal, then lift to
remove (Figure 10)
13. Drain all of the water out of the cold therapy device after each use.
14. Follow directions 2–8 before each use.
TROUBLESHOOTING
Pump will not turn on
Ensure that the power supply connector properly inserted in to port on
unit and that the wall plug has power.
Pad will not get cold
Visually inspect pad to see if water is flowing.
If water is flowing: check pad for pockets of trapped air. Gently massage
the pad to help remove the trapped air. Once water flow appears to
moving freely through the pad, resume usage
If no water is flowing, make certain the unit is properly filled. Refer to
filling instructions.
Check the hose connection to ensure that the coupling is fully engaged.
Check to ensure that the hose is not kinked or pinched by any object.
Water leaking at connector
Unplug device, disconnect hose, visually inspect to ensure coupling
connectors are in the open position and then reconnect hose. Snap or
clicking sound indicates proper connection (Figure 4 & 7).
Leaking
Note: certain conditions such as hot or humid climates may cause
condensation to develop on unit and or pads.
7