Cleaning The Mixer - Silvercrest SSM 550 B1 Instrucciones De Uso

Cleaning the mixer

➩
So that you do not injure yourself on the cutters
, clean the mixer jug
r
handled dishwasher brush.
➩
In a case of stubborn soiling, the mixer jug
can also be cleaned in a dishwasher. For this,
always take the mixing jug
described later.
➩
Clean the lid and the filling cap
w
washer or with the normal washing up.
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
➩
Fill the blender with 750 ml of water and add
e
a few drops of mild detergent. Close the lid
and fit the blender e
Insert the plug into a mains power socket and
activate the Ice Crush/Clean operation a few ti-
mes, such that the cutting blade
through the water at full speed.
Afterwards, rinse the blender
clean water to ensure that all detergent residues
have been removed.
only with a long
e
e
apart, as
e
in a dish-
q
onto the motor block u
r ploughs
out with lots of
e
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
ters ) from the the glass part:
r
w
.
Glass element
Sealing ring
Cutters
Plastic element
➩
Remove the mixer jug
u .
➩
Turn the plastic element
ment anti-clockwise, such that it allows itself to
e
be released from the glass element
Attention!
Take care with the cutters
Risk of injury!
➩
Clean both parts thoroughly in a mild soapy
solution or in a dishwasher.
➩
Replace the plastic part
back onto the glass part
ling ring
- 38 -
e
from the motor block
e
of the mixer attach-
. They are very sharp.
of the mixer jug
. Ensure that the sea-
is correctly fitted.
(with the cut-
.
e