Wiring Instructions - Bosch ARD-AYH12 Manual De Instalación

ARD-AYH12
1.
2.
3.
4.
5.
NOTICE!
Card readers are to be used with a listed access control unit
whose power supply is UL Listed Class 2 or equivalent.
1.2

WIRING INSTRUCTIONS

The ARD-AYH12 is supplied with an 18 inch (45 cm) pigtail,
having a 6-conductor cable.
To connect the reader to the controller, perform the following
steps:
1.
2.
3.
Bosch Access Systems GmbH
Determine an appropriate mounting position for the
reader.
Peel off the back of the self-stick mounting label template
included with the unit and place at the desired mounting
position. If you do not have the self-stick mounting
template label, refer to the Mounting Diagrams in this
manual for the dimensions.
Using the template as a guide, drill the holes (hole size is
indicated on mounting template) for mounting the reader
to the surface.
Drill a " (10 mm) hole for the cable. If mounting on
7/16
metal, place a grommet or electrical tape around the edge
of the hole.
Route the interface cable from the reader to the controller.
A linear type power supply is recommended
Prepare the reader cable by cutting the cable jacket back
1 inches (3,4 cm) and strip the wires
1/4
Prepare the controller cable by cutting the cable jacket
back 1 inches (3,4 cm) and strip the wires
1/4
(1,3 cm).
Splice the reader pigtail wires to the corresponding
controller wires and cover each connection with insulating
tape.
Installation manual
Installation Manual | en
inch (1,3 cm).
1/2
1/2
| V 1.4 | 2010.04
15
inch