Install The High Pressure Hose; Operation; Connect The Water Supply To The Machine; Use The Spray Gun - GreenWorks GPW 2006 Manual Del Operador

3.10 INSTALL THE HIGH PRESSURE
HOSE
4
6
8
1. Push and turn clockwise one end of the high pressure
hose (8) into the inlet coupler (4).
2. Install and tighten the other end of the high pressure hose
onto the water outlet (6) coupler.
4

OPERATION

WARNING
Make sure that all the connections are tight and have no
leakage before operation.
4.1 CONNECT THE WATER SUPPLY
TO THE MACHINE
For easy operation, please use a self-coiling garden hose (not
provided).
WARNING
When you operate the self-coiling hose, make sure that the
hose has no blockage.
WARNING
• The water supply must come from the water main
• Do not use hot water
• Do not use water from ponds or lakes
WARNING
Do the local regulations when you connect the garden hose
to the water supply. Direct connection through a receiver
tank or backflow preventer is usually permitted.
English
Inspect the filter in the water inlet connector before you
connect the garden hose
• If the filter is damaged, do not use the machine until the
filter is replaced.
• If the filter is dirty, clean the filter.
1. Uncoil the garden hose (20).
2. Let the water flow through the garden hose (20) for 30
seconds.
3. Turn the water supply off.
4. Install and tighten the end of the garden hose (20) to the
water inlet (4) connector.
There must be a minimum of 3 m of free hose between the
water inlet and the water supply.
4.2

USE THE SPRAY GUN

For safe control, keep your hands on the gun at all times.
• Pull and hold the spray gun trigger (21) to start the
machine.
9
CAUTION
CAUTION
WARNING
EN