Teka DVU 590 Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 40
DVU560B/DVU560W/DVU590B/ DVU590W
Note: This appliance is equipped with an automatically opening/
closing glass panel.
Be particularly careful as not to trap your fingers or other part of
your body in the glass panel.
Touch to select on/off
During operation mode, touch 1(one) time to select OFF and the fan turns off
automatically after 1(one) minute. Touch 2(two) times, and the fan turns off
instantaneously.
Note: Using the remote control, turn on the appliance by pressing speed
function key (it will start operating at speed F3). Turn off the appliance by
pressing the ON/OFF key.
Touch to turn the light on/off
Speed function key
Touch one time show"F3"to select the high speed.
Touch twice show"F2"to select the medium speed.
Touch thrice show"F1" to select the low speed.
The screen shows cycle , F3-F2-F1.The fan speed in cycle operation, high
speed-medium speed-low speed.
When on Delay and Timer status, Press this key,the delay and timer function
would be closed, and motor will switch to next speed working.
Timer
1.Clock: In stand-by mode press the key to set the clock. Press once the speed
function key to set the hours (change by 1 hour, maximum setting is 24 hours).
Press once the light key to set the minutes (change by 1 minute, maximum
setting is 60 minutes). Press again timer key or do not perform any operation
within 5 seconds - the appliance will automatically save the current clock
setting, and then return into standby mode.
2.Timer (working time): When the appliance is operating, press the key to set
working time. Press once to set the minutes (change by 1 minute, maximum
setting is 60 minutes). In timer mode, the appliance will start countdown after
10 seconds if no operations are performed. When the countdown / working
time has finished, the turbine stops operating, a beep will sound, the glass
panel will close automatically, and the appliance will return into standby
mode.
Locking function key
1 In standby state, touch the key keep 3 seconds ( f o r remote control , less
than 3 seconds) , until the indicator lamp flash, then the door slowly open
and keep the locking state, the users could cleaning the filters.
2 After cleaning touch the ON/OFF key, last 3 seconds (for remote control,
less than 3 seconds) , the hood would be closed automatically and back to
the standby mode.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido