Cleaning And Maintenance; Replacing Light Bulb - Teka DVU 590 Manual De Instrucciones

Safety function
1 While locking the glass panel , when the opening / closing glass panel
encounters obstacle / resistance, it will move in the opposite direction and
then start opening/closing again.
2 If the glass panel encounters obstacle/resistance after the turbine starts/
stops operating , it will stop/lock and the appliance will return into standby
mode.

CLEANING AND MAINTENANCE

CAUTION: NEVER PUT YOUR HAND INTO THE AREA HOUSING THE FAN
WHILE THE FAN IS OPERATING. FOR THE OPTIMAL LEVEL OF
O P E R AT I O N , C L E A N T H E R A N G E H O O D S U R FA C E , FA N , A N D
ALUMINIUM FILTER REGULARLY.
1. Use only mild soap or detergent solutions to clean the cooker hood
surface. Dry surfaces using soft cloth.
2 .Using a stainless steel cleaner to bring the glow back into a stainless steel finish.
3. Clean the filter once a week or according to use status. Press the buckle
of the filter slightly, take off the filter and put it into warm soapy water using
mild detergent, wipe the filter with soft brush. Replace the filter after it is dry.
4 .It is recommended to clean the housing and inner surfaces at least once
every half year or depending on the degree of soiling.
5. Do not use aggressive cleaning agents (i.e. scrubbing or scratching).
6. For cleaning, do not use steam cleaners.

REPLACING LIGHT BULB

To replace LED lamp
Caution: LED lamp cannot replace a new bulb, just can replace a new LED
Lamp. Make sure all the control switches are off, and the cooker hood is
unplugged! Please follow below instructions:
1.Take out the filters, and cut off the wire connection of the lamp.
2.Press the spring according to the arrow direction, then you can take off the
lamp unit.
3.You can replace a new LED lamp unit no more than rating!
4.Then put the lamp unit to the hood in reverse direction. Connect the wire
of the lamp.
5.Fit on the filters.
7