General View Of Application; Application; Coating Materials - WAGNER PROSPRAY 3.20 Manual De Instrucciones

ProSpray 3.20
3

GENERAL VIEW OF APPLICATION

3.1

APPLICATION

The unit performance is conceived so that its use is possible
on building sites for small- to middle-area dispersion work.
The ProSpray 3.20 must only be used indoors.
The sprayer is able for all common varnishing jobs like doors,
door frames, balustrades, furniture, woodencladding, fences,
radiators (heating) and steel parts.
3.2

COATING MATERIALS

PROCESSIBLE COATING MATERIALS
Pay attention to the Airless quality of the
coating materials to be processed.
Dilutable lacquers and paints or those containing solvents,
two-component coating materials, dispersions, latex paints,
release agents, oils, undercoats, primers, and fillers.
No other materials should be used for spraying without
Wagner's approval.
FILTERING
Despite suction filter and insertion filter in the spray gun,
filtering of the coating material is generally advisable.
Stir coating material before commencement of work.
Attention: Make sure, when stirring up with
motor-driven agitators that no air bubbles are
stirred in. Air bubbles disturb when spraying
and can, in fact, lead to interruption of
operation.
VISCOSITY
With this unit it is possible to process highly viscous coating
materials of up to around 20.000 MPa·s.
If highly viscous coating materials cannot be taken in
by suction, they must be diluted in accordance with the
manufacturer's instructions.
TWO-COMPONENT COATING MATERIAL
The appropriate processing time must be adhered to exactly.
Within this time rinse through and clean the unit meticulously
with the appropriate cleaning materials.
COATING MATERIALS WITH SHARP-EDGED
ADDITIONAL MATERIALS
These have a strong wear and tear effect on valves, high-
pressure hose, spray gun and tip. The durability of these parts
cane be reduced appreciably through this.
GENERAL VIEW OF APPLICATION
7