Special Safety Instructions; Technical Data - Rothenberger H 600 Instrucciones De Uso

16 Do not leave any tool keys inserted. Before switching on, check to see that keys and ad-
justment tools have been removed.
17 Avoid unintentional activation. When plugging the tool in, make sure that the switch is
turned off.
18 Use outdoor extension cords. When outdoors, use only extension cords that are approved
and appropriately marked.
19 Be alert. Pay attention to what you do. Approach your work sensibly. Do not use the electric
tool when you are distracted.
20 Check the electric tool for damage. Before using the electric tool, you must inspect safety
equipment or slightly damaged parts carefully to ensure that they work properly and as in-
tended. Check to see that the moving parts operate freely and don't stick, and to make sure
no parts are damaged. All parts must be mounted properly and meet all the conditions for
ensuring trouble-free operation of the electric tool.
Damaged safety equipment and parts must be properly repaired or replaced by a profes-
sional facility, unless otherwise indicated in the user manual. Damaged switches must be
replaced by a customer service facility.
Never use an electric tool whose switch cannot be turned on and off.
21 Caution. Using other insertion tools and accessories may cause injury.
22 Have your tool repaired by an electrical expert. This electric tool meets applicable safety
requirements. Repairs must be made only by an electrical expert using original replacement
parts. Otherwise accidents many occur.
1.3

Special safety instructions

On the building site or in damp rooms only connect the device via a FI protective circuit breaker!
Third-party tools and accessories must have approval up to at least 600 bar!
Before changing the expander pistol, it is essential that the device is depressurised (take the
foot from the foot-operated switch)!
Check the expander head for damage before putting into operation! Any minimal damage can
become a danger to persons and the surroundings during operation!
Each expander head must always be checked for adjustment before using with the hydraulic pis-
tol!
Insert pipes firmly! Always lay the pipes parallel, never at an angle to the expander axis! Never
reach into the immediate working area!
Always work with the quickly assembled tool tray. You will protect yourself and other persons
from accidents and in doing so take good care of the tools!
2

Technical Data

Nominal current ........................... 2,1 A
Rated power input ........................ 1,2 kW
Working pressure ......................... 80 – 600 bar
Max. operating pressure .............. 700 bar
Delivery rate ................................ 0,82 l/min
Operating time ............................. 100 % - 80 bar
Weight ............................................ 10,5 kg
Protection type ................................ IP 54
Noise pressure level (L
Sound power level (L
The noise level during operation can exceed 85 dB (A). Wear hearing protection!
Measured values determined in accordance with EN 61029-1:2010.
Vibration total value .............................................................
12
) ............... 66 dB (A) ¦ K
pA
) ................. 77 dB (A) ¦ K
WA
≤ 2,5 m/s
ENGLISH
3 dB (A)
pA
3 dB (A)
WA
2 2
¦ K= 1,5m/s