Descargar Imprimir esta página

SEVERIN KA 5740 Instrucciones De Uso página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
No responsibility will be accepted if damage
results from improper use, or if these
instructions are not complied with.
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualified
personnel, including the replacement of the
power cord. If repairs are needed, please
send the appliance to one of our customer
service departments. The addresses can be
found in the appendix to this manual.
Caution: The water reservoir heats up
during operation.
First use
First clean your coffee maker by operating it
once or twice with approx. 6 cups of fresh
cold water, but without using ground coffee
as described in the section Making coffee.
The Vapotronic system will automatically
switch off the water reservoir element. It
cannot be switched off manually
Making coffee
Open the swing-out filter holder and take
off the filter holder lid.
Insert a
size-4 paper filter into the filter
insert, first folding down the perforated
sides of the filter.
We recommend the use of fine-ground
coffee:
-
for normal-size cups use around 6 g (= 2
teaspoons) of ground coffee;
-
for small cups use around 4g (= 1½
teaspoons.
Depending on your personal taste, the
actual quantity used may vary.
Replace the filter holder lid and close the
swing-out filter.
Open the lid of the fresh-water container and
fill it with the desired quantity of cold water,
observing the minimum fill amount (2
cups).
Two measuring scales
help you to find the correct amount of fresh
water:
-
left
scale for normal-size cups (around
125 ml).
-
right
scale for small cups.
on the valve unit
Caution: To prevent boiling water from
being forced out, be careful not to exceed
the maximum water level of 8 medium-
sized cups.
Close the water reservoir lid. This is
important as the Vapotronic system can
only operate when the lid is closed
Fit the aroma-protection lid on the carafe,
then place the carafe on the base plate.
Press the start button; the indicator light
comes on and the heating process starts.
With the water reservoir filled to its
maximum, it will take about 5 minutes to
bring the water to the boil.
Once the optimum brewing temperature
has been reached, the valve opens and the
brewing cycle begins.
The Vapotronic system will switch off the
heating process automatically.
The coffee starts flowing through the filter
into the heat-preserving carafe.
The indicator light goes out once the
filtration cycle is complete.
Remove the carafe from the base plate.
Take off the aroma-protection lid and
replace it with the screw-in lid for the
carafe.
The freshly brewed coffee can be poured
without having to remove the screw-in lid.
To pour, simply rotate the screw-in lid anti-
clockwise half a turn. Turn the lid back
again after pouring.
This coffee maker has been designed for
domestic use only. Should you wish to start
several brewing cycles one after the other,
allow the machine to cool down for at least
5 minutes with the reservoir lid open before
re-using it. Use cold water only to refill the
water reservoir.
Warning: Remember that the water reservoir
and its lid are still hot after the brewing cycle
has been completed and hot steam may escape
from the reservoir when opening the lid
(danger of scalding).
Heat-retaining carafe
For technical reasons the screw-in lid does
not close hermetically. Therefore always hold
10

Publicidad

loading