Rupes RE21A Instrucciones De Uso página 9

PARTS OF THE TOOL
1 - Identification plate
2 - Compressed air on/off lever
3 - Speed control
4 - Tool body
5 - 29 mm. int. Ø suction pipe connection
6 - Compressed air connection with 1/4" thread
7 - Suction cowling
8 - Base plate
9 - Velcroed drilled rubber plate
10 - Paper clamping lever (RE21AC)
11 - Abrasive paper punching device (RE21AC)
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having
been damaged during storage or transport;
- the tool is complete; check that the number and type of
components comply with that reported in this instruction
booklet;
- the available compressed air production and distribution plant is
capable of satisfying the requirements reported on the tool's
identification plate reproduced and explained on page 11.
ASSEMBLING THE TOOL
Assemble the compressed air connection (not supplied) by
screwing it into its seating (6).
COMPRESSED AIR CONNECTION
The tool is supplied without the compressed air connection; the
user can use either a quick release coupling or hose type
connection according to his needs, purke they have an hole of air
passing mm. 8. In the latter case the air line must be fixed to the
nozzle by a hose clip.
INSERTING THE ABRASIVE PAPER
RE21AC
- Lift the paper clamping lever (10) by pressing the lever release;
- insert the abrasive paper under the lever until it rests against the
stop, then release the lever and that the holes in the paper coin-
cide with the suction holes in the rubber plate;
- repeat this operation on the opposite side of the plate, keeping
the paper taut and checking that the edges are parallel with the
edges of the plate before releasing the lever.
RE21A - RS21A - RE21AL - RE21AM
- Press the velcro backed abrasive paper in position, ensuring
that the holes in the paper coincide with the suction holes in the
rubber plate;
- make sure that there is no dust or other matter on the drilled
rubber plate.
BEFORE STARTING THE TOOL
Ensure that:
- the speed control (3) is in MAX position;
- the compressed air feed line and connection are in perfect
working order;
- the start lever is working properly. This must be done with the air
supply switched off;
- all the components of the tool are mounted correctly and do not
show any signs of damage.
STARTING AND STOPPING
- Starting: push the control lever (2) forward towards the body of
the tool and keep it pressed.
- Stopping: release the control lever.
TEST RUN
Start the tool and check that there are no unusual vibration.
Otherwise switch-off the tool immediately and eliminate the
cause.
9