Unpacking; Positioning - Nordcap TR-RED 3/1 Manual De Instrucciones

UNPACKING

Check that the packaging is intergal before removing it, contesting and writing any damage detected on the
delivery note. After having removed the packaging make sure that the appliance is integral; if it is damaged, inform
the dealer immediately via fax or registered letter with receipt of acceptance and if damage is such to jeopardise
machine safety do not install it until a qualified technician has intervened. The packaging (plastic bags, boxes, nails
etc.) must not be left within reach of children and pets as it is a potential danger.

POSITIONING

For correct installation, check that in the area of installation the air inlets are not obstructed, which are necessary
for correct functioning of the machine. The machine must be installed and levelled to guarantee stability; any other
different solution for installation must be agreed and approved by the manufacturer. If the cabinet has wheels,
position it in a flat area and block them before powering the appliance.
DROP IN MODEL:
Weights and sizes can be found on the technical sheets.
The water inlet & outlet must be connected to the water supplay.
The electrical panel can be positioned at a maximum distance of 1.2 m from the motor compartment.
Z = Housing structure
Y = Air vents
X = Hole for electrical panel
The drop in is an appliance which must be inserted
inside of housing structure designed to support the
weight of the machine when fully loaded.
The housing structure must be provided with adequate
air vents. These must be easily removable for
inspection and
compartment and they must have the proper size.
The housing structure is provided with a hole to insert
the electrical panel.
Incorrect installation
The machine produces an hot air flow which cannot be
contained inside of the housing structure. The arrows indicate
an incorrect hot air flow.
maintenance of the technical
7