Descargar Imprimir esta página

BABYTREND TJ79 Manual De Instrucciones página 7

Publicidad

ASSEMBLY MONTAJE ASSEMBLEE
• With the wheel in position, install the axel
4)
nuts and tighten with standard crescent,
box, or open end wrench. You should
feel significant resistance and the wheel
should be held tightly in place (Fig. 4).
• Posicione la rueda correctamente. Ponga las
tuercas en el eje y atorníllelas con una llave
inglesa abierta o de pipa. Apriételas hasta
que sienta bastante resistencia. La rueda
debe quedar fija (Fig. 4).
• Avec la roue en place, installez les écrous
d'essieu et serrez-les avec une clé à molette
standard, polygonale ou à fourche. Puisque
vous devriez sentir une forte résistance, la
roue doit être maintenue fermement en place
(Fig. 4).
13
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ASSEMBLY
MONTAJE AS-
SEMBLEE
Fig. 4
7
8
ASSEMBLY MONTAJE ASSEMBLEE
FENDER
GUARDABARROS
PARE-CHOCS
To secure the fender to the frame, use the 4
screws provided.
Para sujetar el guardabarros al armazón, use los
4 tornillos provistos.
Pour attacher le pare-chocs au cadre, utilisez les
4 vis fournies.
• Examine the bottom of the front fender. You
5)
will notice four 1/4 inch diameter plastic
tubes protruding from the bottom (Fig. 5a).
• These tubes must be lined up with the holes
in the front frame assembly (Fig. 5b).
• Line up the front fender and press onto the
front frame assembly (Fig. 5c).
• Insert the 4 screws through the underside
of the front frame assembly into the front
fender's plastic tubes. Tighten the screws
only until snug (Fig. 75).
DO NOT OVER TIGHTEN.
• Examine la parte inferior del guardabarros
delantero. Notará cuatro tubos plásticos de
¼ pulgada de diámetro que sobresalen de la
parte inferior (Fig. 5a).
• Estos tubos deben estar alineados con los
agujeros del armazón delantero (Fig. 5b).
• Alinee el guardabarros delantero y
presiónelo en el armazón delantero (Fig. 5c).
• Introduzca los 4 tornillos por debajo del
armazón delantero en los tubos plásticos
del guardabarros delantero. Ajuste bien los
tornillos sin forzarlos (Fig. 5d).
NO AJUSTE DE MÁS.
Copyright © 2016 Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
Fig. 5a
Fig. 5b
Fig. 5c
Fig. 5d
14

Publicidad

loading