3. To finish the measurement
1. After the cuff deflates completely, and you want to finish your measurement, just press "
will be turned off.
2. But if you forget to turn off the power, this unit will turn off automatically within 3 minutes.
LOW POWER WARNING
After the battery warning appears, the device is blocked until the batteries have been replaced.
For best results, use "AAA" Alkaline Batteries.
If the blood pressure monitor is unused for long periods,please remove the batteries from the device.
HOW TO SET TIME AND DATE
Generally, LCD panel displays Month / Date / Hour / Minute Regarding time message, If you desire to adjust Year / Month
/ Date and Time setting, please follow the procedures as below:
1. Press "
" at least 5 seconds.
2. You can start "year" setting when "year" digit blinks.
3. Then you press "
4. You also can press "PAGE" to backward "year" Setting.
5. After finishing Year Setting, you can press "
Setting when Month/Date/Hour and Minute digits blink as you desire.
TROUBLE SHOOTING
Phenomenon
Nothing displayed when
you push the Start button.
"Err P" shown on LCD
panel
"Err 1" shown on LCD
panel
ENGLISH
" to forward "year" Setting.
Problem
Are the batteries exhausted?
Are polarities of the batteries in
wrong position?
Fail to inflate
Deflate too fast
" button again. Now, you can adjust Month/Date/Hour and Minute
Solution
Replace the batteries with new ones.
Insert batteries in the correct direction.
Please check if the cuff is too loosen and fasten it.
Please send it to service point.
8
" button for then the power