Makita UN490D Manual De Instrucciones página 5

ENGLISH (Original instructions)
1. Battery cartridge
2. Indicator lamp
3. Control grip
4. Switch trigger
5. Hanger (suspension point)
6. Loop handle
7. Front grip
8. Shaft
9. Angle lock
10. Gear case
11. Blades
SPECIFICATIONS
Strokes per minute, Low/High
Cutting blade angle
Overall length
Rated voltage
Standard battery cartridge (and charger)
Always keep the combinations of battery/charger on the
right columns.
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Noise
Sound pressure level average
L (dB (A))
PA
82.9
• Wear ear protection.
Vibration
Left hand (Front grip)
2
a (m/s )
h
5.5
• The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of exposure in
the actual conditions of use (taking account of all parts
of the operating cycle such as the times when the tool
Explanation of general view
12. Red indicator
13. Button
14. Indicator lamps
15. CHECK button
16. Lock-off button
17. Reversing switch
18. A position depressed for normal
operation
19. B position depressed for
removing a branch in blades
20. Speed change switch lever
Model
Blade length
Net weight
Uncertainty K (dB (A))
2
2
Uncertainty K (m/s )
1.5
BL3622A (DC36WA)/
BL3626 (DC36RA)
Sound power level average
L (dB (A))
WA
93.2
Right hand (Rear grip)
2
a (m/s )
h
2.0
is switched off and when it is running idle in addition to
ENG901-1
the trigger time).
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.................. Take particular care and attention.
................ Read and follow the instruction manual.
............... Wear protective helmet, eye and ear
............... Wear protective gloves.
21. Handle
22. Bolt
23. Hex wrench
24. Socket wrench
25. Battery guard
26. Clamp
27. Clamp cover
28. Arrow mark
29. Nut
30. Truss bolt
UN490D, BUN490
490 mm
0 - 1,400/0 - 2,000 (min
135° (up 45°, down 90°)
2,595 mm
D.C. 36 V
BL36120A (DC3600)
6.9 kg
Uncertainty K (dB (A))
2.2
2
Uncertainty K (m/s )
1.5
protection.
-1
)
11.8 kg
Applicable standard
ISO10517
Applicable standard
ISO10517
END115-1
5